Tool-Stop

This three-piece set combines the popular rail and stile bits with 3-1/2-inch diameter traditional raised panel bit. Each bit is individually balanced and designed to be used with a 1/2-inch shank table mounted router. Use with 3/4-inch stock. Wooden storage case included. Cuts all composition materials, plywood, hard wood, and soft wood. Use on table-mounted portable routers.

very nice and sharp set
November 6, 2000

Reviewer: David West
from Castaic
CA United States

I just purchased the 3 piece cab. bit set from freud and I am very excited. The set came within a few days of ordering- thanks Amazon. The bits are extremely sharp and the finish is excellent. The box that comes with the set is well constructed to keep the bits safe and free from dust, which is nice. The only concern that I initially had was whether or not the 3 1/2" bit would fit in my router base opening. I have a 7539 p.c. router and the opening is 3 1/2". I had to file the opening just a little to make the bit fit. I am sure that you will find this most acceptable. The cuts with the bits are very clean, just like the ads say, and there are no pieces of fuzz on the top of the profile on the end grain. This will save some valuable time. All in all, very good product and the price was extremely good. In fact, the cheapest I could find.

*Click* Here
to go to the
*Router Bits Page*

*Click* Here
for the
Porter~Cable
*Accessory Page*

*Click* Here
to Visit the
*Router Page*

Amazon Search Engine